نوع مقاله : پژوهشی
نویسندگان
1 دانش آموخته دکترای مهندســی آب، دانشگاه شــهید چمران اهواز
2 استاد دانشگاه شهید چمران اهواز
3 استادیار پژوهشکده حفاظت خاک و آبخیزداری، سازمان تحقیقات، آموزش و ترویج کشاورزی، تهران
چکیده
کلیدواژه‌ها
عنوان مقاله [English]
نویسندگان [English]
The saturated hydraulic conductivity is one of the most important and widely used geotechnical parameters. This parameter depends on properties of the fluid, poresize distribution, and characteristics of the solid surfaces. Because the latter two are notnecessarily constant, the hydraulic conductivity may vary significantly. So far several empirical relationships for estimation of the hydraulic permeability with respect to the type of materials have been presented. In this research seven applicable method including Terzaghi, Kozeny-Carman, Chapuis and Aubertin, modified Navfac, Shahabi et al., Mbonimpa et al. and Chapuis were evaluated. Four samples of sandy soils (R1 to R4) with a rather wide range of particle sizes were prepared and were compacted within the Plexiglas box. After providing the head of 0.5,1 and 1.5 meters; flow discharge and static pressure were measured which result phreatic and iso-potential lines extraction. By applying the results of the model, the accuracy of some common methods used in the estimation of saturated hydraulic conductivity of sandy soils was evaluated. For the samples (R1 to R4), the coefficient of permeability was 0.0051, 0.048, 0.076, and 0.19 cm/s respectively. Due to the limited range of input parameters, the method of Shahabi et al. can be used only for the R4 sample; so this method was discarded from statistical analysis. Comparing the results of laboratory test with common methods shows the methods of Kozeny-Carman and Chapuis and Aubertin were more accurate according to the highest R2 and lowest RE and RMSE. These methods were based on effective parameters and the results of accurate laboratory studies. The method of Mbonimpa et al. (2002) indicates the maximum deviation from observed values which may be due to the sensitivity of this model to void ratio (e). Also the results shows by increasing of void ratio the error of Mbonimpa et al. method increases.
The saturated hydraulic conductivity is one of the most important and widely used geotechnical parameters. This parameter depends on properties of the fluid, poresize distribution, and characteristics of the solid surfaces. Because the latter two are notnecessarily constant, the hydraulic conductivity may vary significantly. So far several empirical relationships for estimation of the hydraulic permeability with respect to the type of materials have been presented. In this research seven applicable method including Terzaghi, Kozeny-Carman, Chapuis and Aubertin, modified Navfac, Shahabi et al., Mbonimpa et al. and Chapuis were evaluated. Four samples of sandy soils (R1 to R4) with a rather wide range of particle sizes were prepared and were compacted within the Plexiglas box. After providing the head of 0.5,1 and 1.5 meters; flow discharge and static pressure were measured which result phreatic and iso-potential lines extraction. By applying the results of the model, the accuracy of some common methods used in the estimation of saturated hydraulic conductivity of sandy soils was evaluated. For the samples (R1 to R4), the coefficient of permeability was 0.0051, 0.048, 0.076, and 0.19 cm/s respectively. Due to the limited range of input parameters, the method of Shahabi et al. can be used only for the R4 sample; so this method was discarded from statistical analysis. Comparing the results of laboratory test with common methods shows the methods of Kozeny-Carman and Chapuis and Aubertin were more accurate according to the highest R2 and lowest RE and RMSE. These methods were based on effective parameters and the results of accurate laboratory studies. The method of Mbonimpa et al. (2002) indicates the maximum deviation from observed values which may be due to the sensitivity of this model to void ratio (e). Also the results shows by increasing of void ratio the error of Mbonimpa et al. method increases.
کلیدواژه‌ها [English]
)